brewpi.py had a dead -m/--model CLI arg and sude/*.json schedules were
pure data with no code to drive them, despite the README documenting
them as if they were already wired up.
Add components/sud.py's Sud, which loads a sude/*.json schedule and
steps through its Rasten (ramp -> hold -> optional wait-for-user ->
next rest), and tasks/sud.py's SudTask, which drives the temperature
controller's theta_soll/heatrate_soll from the current rest and
switches the stirrer between continuous (ramping) and intermittent
(holding, via stirrSpeedRast/stirrDutyRast/stirrCycleTime) operation.
Exposes progress on a new "Sud" WebSocket channel and accepts
Start/Confirm commands. Enabled via a new optional top-level "sud"
config key (see config.json.templ/.sim).
"Reached target" is detected via abs(theta_ist - theta_soll_set) <
tolerance rather than tc.state == HOLD, since the latter can still
read HOLD left over from the previous rest for one tick after a new
target is pushed (tc.state only updates on the controller's own,
independently-scheduled process() tick).
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
Both TODO.md backlogs and the README's architecture section still
described the Kalman-filter/heat-diffusion design that's since been
replaced by the delay-line Pot model and Kalman-free Smith predictor.
Check off the items that rewrite already fixed (heat-loss units,
transport delay vs. single-pole lag, three-Kalman-tuning), note how
the kn/sensor-noise item was resolved differently than proposed, and
add newly-spotted issues: brewpi.py wiring set_model_power
unconditionally (breaks pid_type "Normal"), kalman.py being dead code
in production, stale Kalman/kn keys in the config templates, and
debug print()s left in Pot.process().
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
PyQt5.Qwt isn't pip-installable; it only existed via the apt package
python3-pyqt5.qwt, so pip-installing client/requirements.txt's plain
PyPI PyQt5 always crashed with "No module named 'PyQt5.Qwt'".
Qwt was only used for 3 QwtSlider widgets (Slider_temp_soll,
Slider_pwr_soll, Slider_speed_soll). Swap them for stock QSlider in
brewpi.ui, regenerate brewpi_win.py via pyuic5, and update
brewpi_gui.py's setLowerBound/setUpperBound calls to QSlider's
integer-only setMinimum/setMaximum. The GUI now runs from a plain
`pip install -r client/requirements.txt` venv with no system PyQt5
packages required.
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
Splits the server, GUI client, and websocket layer into their own
packages with dedicated requirements.txt files, and adds a README
documenting the project's architecture and usage.
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
jensandClaude Sonnet 4.6