Add Sud.derive_plant_params(), which combines pot_mass/pot_material/
grain_mass/water_mass into a single lumped (mass, specific heat) pair
using approximate specific-heat constants for water, grain, and (by a
small material lookup table) the pot itself. demo_sud.py now builds
its plant_params from this instead of hardcoded C/M values, keeping
L/Td as the only manually-tuned plant parameters.
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
_advance() multiplied "duration" by 60, treating it as minutes;
stirrer_speed (percent) and stirrer_time_on/off (seconds) were already
handled correctly with no conversion. Also fix the README's "duration
minutes" wording to match.
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
sude/sud_0010.json moved from a list of combined ramp+hold+wait
"Rasten" with global stirrer constants to a flat "schedule" list of
explicit {"type": "heat"|"hold", ...} steps, each carrying its own
stirrer_speed/stirrer_time_on/stirrer_time_off and an optional
user_wait_for_continue (+ user_message).
- components/sud.py: Sud now tracks the current `step` instead of
`rast`; "heat" steps enter RAMPING (advanced externally via
temp_reached()), "hold" steps enter HOLDING and count down
`duration` minutes (0 if omitted). Either step type can pause in
WAIT_USER via user_wait_for_continue, surfaced through the new
user_message attribute.
- tasks/sud.py: SudTask only pushes theta_soll/heatrate_soll on
"heat" steps, converts each step's stirrer_time_on/off into a
duty_cycle/cycle_time on every step change (replacing the old
state-based RAMPING/HOLDING stirrer switching), and broadcasts
user_message changes. Stirring is now fully schedule-driven instead
of implicitly stopped on WAIT_USER/DONE (DONE still stops it, since
there's no step left to read settings from).
- scripts/demos/sud/demo_sud.py: mirrors the same step-driven wiring.
- README's Mash schedules section rewritten for the new schema.
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
brewpi.py had a dead -m/--model CLI arg and sude/*.json schedules were
pure data with no code to drive them, despite the README documenting
them as if they were already wired up.
Add components/sud.py's Sud, which loads a sude/*.json schedule and
steps through its Rasten (ramp -> hold -> optional wait-for-user ->
next rest), and tasks/sud.py's SudTask, which drives the temperature
controller's theta_soll/heatrate_soll from the current rest and
switches the stirrer between continuous (ramping) and intermittent
(holding, via stirrSpeedRast/stirrDutyRast/stirrCycleTime) operation.
Exposes progress on a new "Sud" WebSocket channel and accepts
Start/Confirm commands. Enabled via a new optional top-level "sud"
config key (see config.json.templ/.sim).
"Reached target" is detected via abs(theta_ist - theta_soll_set) <
tolerance rather than tc.state == HOLD, since the latter can still
read HOLD left over from the previous rest for one tick after a new
target is pushed (tc.state only updates on the controller's own,
independently-scheduled process() tick).
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
jensandClaude Sonnet 4.6